![]() If this happens, air pockets will have likely formed between the processor and heatsink and the previous steps will need to be performed again. In this case, carefully wipe excess paste up with another coffee filter until none remains on your board.Īfter the heatsink and CPU are reunited, it is crucial not to pull them apart or the seal will be compromised. If any thermal paste comes out the sides, then too much was applied. Gently place the heatsink directly on top of the CPU where it was first attached. Thermal paste is generally non-conductive, but there’s no need to make a mess all over your board. ![]() You’re almost ready to start applying the thermal paste! By now, your CPU and heatsink should look something like this:Īpply a small amount of paste directly to the surface where the heatsink will rest. Wipe the small fibers/hairs off with a lint-free cloth or coffee filter. Remove ALL the thermal paste with the Q-tip, leaving nothing behind. Maybe you have a cool alcohol dispenser like we do? If not, you'll still manage. Installing a heatsink is a bit tricker, but just unscrew to remove.ĭouse your Q-tip in rubbing alcohol (90% or higher) to prepare for removing the old paste from the CPU and the bottom of the heatsink. Take your screwdriver and carefully remove the screws attaching the heatsink to the CPU. If you're unsure whether you can skip the logic board removal on a particular model, ask in the comments below. The logic board was removed prior to replacing the paste for this example however on some models, it can be done without removing it at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |